- Vinyl records
- Analog tapes
- Radio (analog and internet)
- Music files in all gmerlin supported formats on 2 PCs
This had been on my wish list for many years, but I was too lazy to lay cables through the whole apartment (especially through doors, which should be lockable). And since there are lots of signal paths, the result would have been a bit messy. Dedicated wireless audio solutions didn't really convince me, since they are mostly proprietary technology. I never want to become a victim of Vendor lock-in (especially not at home).
When I first read about the WLAN-radios I immediately got the idea, that those are the key to the solution. After researching a lot I found one radio which has all features I wanted:
- Stereo (if you buy a second speaker)
- Custom URLs can be added through a web interface (many WLAN radios don't allow this!)
- Ogg Vorbis support (so I can use Icecast2/ices2 out of the box)
Now I had to set up the streaming servers. The icecast server itself installs flawlessly on Ubuntu 8.04. It's started automatically during booting. For encoding and sending the stream to icecast, I use ices2 from the commandline. 2 tiny problem had to be solved:
- Ubuntu 8.04 uses PulseAudio as the sound server, while ices2 only supports Alsa. Recording from an Alsa hardware device while PulseAudio is running doesn't work.
- For grabbing the audio from a running gmerlin player the soundcard and driver need to support loopback (i.e. record what's played back). This is the case for the Audigy soundcard in the Media PC, but not for the onboard soundcard in the desktop machine.
pcm.pulseThe Alsa devices to be written into the ices2 configuration files are called
deviceline is hardware dependent. Use the PulseAudio Manager (section Devices) to find out the corresponding name for your card. If your card and driver support loopback, the pulsemon device isn't necessary.
Some fine-tuning can be done regarding encoding bitrate, buffer sizes and timeouts. When I optimized everything for low latency, icecast considered the WLAN radio too slow and disconnected it. More conservative settings work better. Encoding quality is always 10 (maximum), the corresponding bitrate is around 500 kbit/s.